Click image to view full size image
Coil Winding Tungsten Carbide Nozzle with Bending strength 2300n/mm for copper wire 0.16
Coil Winding Nozzles:
Tungsten Carbide nozzle is used on coil winding machine.it is made precisely of super
hard alloy and enjoys the hardness over HRA90.degree while the anti bending degree
reached over 2300N/mm.Two terminals and the inner and outlet are all receive mirror
surface treatment to ensure enameled wire makes no scrape. High hardness, resistance
to flexure, block and impact .
Key advantages of Tungsten Carbide Nozzle :
1. High Wear Resistance
This is assured by the choice of materials for wear elements possessing. Hardness
Value: 1800 ~ 2200Vickers, or 3times that of case hardened steel. Body material is stainless
steel for structural supports, not wear-bearing.
2. Scratch-Proofing
Eliminate wire insulation film damage, low friction resistance, stable wire tension.
The wireguiding surfaces are mirror finished by diamond lapping to a surface roughness of
2 4 micro inches Ra or better, material permit.
3. Straightness and Stiffness
Straightness and Stiffness are defined by the wire exit being concentric and inflexible
with respect to the nozzle locating. In plain terms, the wire should exit from the nozzle
concentric to the locating, To within 0.02 mm, with or without load. A geometric
Characteristic presentation is shown at upper left. Concentricity to within 0.01mm.
4. Precise Exit Radii
Because the coil winding nozzle's Exit Radii governs the angle of the wire exit from one
coil to the next, it should be monitored to + / - 0.025 mm. This is done by digital measurement,
shown at upper right.
Specification and description:
The the measurements drawing as follow please /confirm/i your nozzles size according
to your winding machine and coil products.
